Troubleshooting Guide - Wolf CT30I/S Instructions Manual

Troubleshooting Guide

DIAGNOSTICS MODE
To enter Diagnostics Mode, the unit must be in Lock
Mode (see Section 3, Electronic Control, page 3-6, for a
description of how to put the unit into Lock Mode).
Press and hold the universal OFF key for 5 seconds,
the controls will enter Diagnostics Mode 1. A beep will
sound after 5 seconds to let the user know that they can
lift their finger from the key (See Figure 5-1).
NOTES:
• If any other keypad sensor detects another input
signal, Diagnostics Mode will not engage.
• If the universal OFF key is not released after seven
seconds, Diagnostics Mode will be cancelled and
not engage. The unit will return to Lock Mode.
• All Induction Coils are disabled and there will be no audible signals during Diagnostics.
• If after 60 seconds no other inputs are detected, the controls exit Diagnostics Mode and return to Lock Mode.
• While in Diagnostics Mode, 1200W will refer to front 1200W coil for all sized cooktops, and 3000W will refer to
the control that operates the rear 3000W boost coil for all sized cooktops.
Upon entry to Diagnostics Mode, the LED Test will automatically start. To step through tests, the user will use the "+"
and "-" keys of the 3000W coil (the rear element, HI-POWER). The 3000W control will step up one LED for each
test to identify which test is being performed. See the individual descriptions for each model, in Figure 5-2 below).
LED Test (First Test)
1. Upon entry to Diagnostics Mode, the LED Test will automatically start. To step through tests, the user will use
the "+" and "-" keys of the 3000W (the rear element, HI-POWER) inductor (See Figure 5-2).
2. During this test, all LEDs will stay on. Press the "+" or "-" keys of the 1200w inductor to turn all LED's on or off.
3. To step back to the last known state test, press the "-" key under the HI-POWER Control Zone that pertains to
the appropriate Model being Diagnosed.
COOLING FAN TEST (Second Test)
1. To enter Cooling Fan Test, press the "+" key of the 3000W inductor. The bar graph will show 2 LEDs.
NOTE: This Test is only used for units that include a 120mm cooling fan (prior to serial #17600000).
2. The 1200W inductor will have all of the bar graph lights illuminated.
3. The cooling fan relay will turn ON causing the cooling fan to turn ON.
4. Press the "-" key of the 1200W inductor, all bar graph LEDs (1200W Control only) and fan will turn OFF.
5. Press the "+" key of the 1200W inductor, all bar graph LEDs (1200W Control only) and fan will turn ON.
6. Press the "-" key on the 3000W inductor to step back to the LED Test.
#821684 - Revision B - March, 2013
Induction Cooktop (CTI) Series
Induction Cooktop (CTI) Series
Press and Hold the OFF Key for 5 sec-
onds. Unit will beep after 5 seconds
Figure 5-2.
5-2
CLEAR
Figure 5-1. Diagnostic Mode.
OFF