Mounting The Juice Module; Connecting The Harness; Final Inspection - Edge Products Attitude Installation Instructions And Manual

GM Juice/Attitude Manual Edge Products

Mounting the Juice Module

1. The Power Edge Juice Module can mount on top of or to the side of the
black plastic fuse box cover located on the driver's side fender (Use caution
when mounting the Juice on top of the fuse box as the Hood may sometimes
come in contact with the module). Attach the module using the supplied
Velcro, allowing enough harness movement for removal of the fuse box
cover.

Connecting the Harness

2. Disconnect both stock
connectors by squeezing the ears
on the backside of the connector
and pulling the gray lever.
3. Gently insert the Juice
connectors and lock in place with
the gray levers, and then gently
connect the stock connectors to the
other end of the Juice connectors.
Notice: Use caution when inserting connector bodies. If the connector does not slide
smoothly, remove the connector, inspect the pins, and retry installation.

Final Inspection

4. Recheck all connections for a properly secure installation. Using the
supplied wire ties, secure the wiring harness to prevent possible damage.
5. Start the engine. The engine should start and run like a stock truck. If the
engine does not start or run properly, turn off the motor, remove the keys
from the ignition, then remove the juice module and inspect the pins inside
both connectors. Straighten pins or clear foreign material from the pins and
connector surfaces, and then re-install the connectors. If failure conditions
still exist, contact your dealer or Edge Products, LLC. When trying to
restart, make sure that the key has been turned off for at least 10 seconds
before cranking the engine.
10