Table of Contents
Advertisement
Edge EZ User Manual
The Edge EZ Module:
This picture shows the Edge EZ Module with the harness cable (Note: Harness
shown is for years 1998.5-2000. 2001+ is slightly different)
Data Link
connector-
(May require
adapter)
MAP Sensor.
Disconnect
engine
harness and
insert this
harness 'T'
Power Level Selector
Switch Connection.
(connect to pwr lvl switch.)
Module Installation
The Edge EZ Module can mount on the flat black plastic fuse box cover located on
the driver's side fender. Adhere the module using the supplied Velcro, allowing
enough harness movement for removal of the cover.
Harness Connector
Your EZ module is equipped with a harness that can be disconnected at the EZ
module itself (See figure 1C). It is important to make sure that your EZ module is
always connected to the harness when the wiring harness is connected to the truck,
otherwise the truck may not run properly, or may trip engine "codes."
Data Link (2000)
adapter- use to
adapt Data Link
to engine.
FIGURE 1A
FIGURE 1B
8
Edge Products
Edge EZ
power Module
Power Level
Selector Switch.
Connect this
green connector to
green connector
on EZ harness
Hide quick links:
Advertisement
Table of Contents
