Chevy/Gm Attitude Getting Connected - Edge Products Attitude Installation Instructions And Manual

Attitude

Chevy/GM Attitude Getting Connected

The Attitude monitor connects under the hood to the Edge Juice module.
Follow these steps to install the Attitude:
1. Place your Attitude monitor on the dash of your vehicle approximately
where you want it installed and, with the driver's door open, feed the cable
through the open door, and into the engine compartment via the slot near the
hood hinge.
2. Determine where you want to attach the Attitude mounting bracket and
insert it into your dashboard. The bracket fits well in the seam of the dash
board by separating the seam slightly and sliding in the bottom portion of the
bracket until it snaps into place (see figure 1). The following pictures
demonstrate how to best mount the Attitude with the new bracket.
Figure 1
Figure 2
Edge Products
The bracket fits well in
the seam of the dash
board by separating the
seam slightly and sliding
in the bottom portion of
the bracket until it snaps
into place.
After the bracket is
mounted, use the supplied
two sided tape to secure
the Attitude to the
bracket.
19