1. Please be cautious that neckties, necklaces, long hair and clothing are
kept well away while operating the laminator.
2. Prevent children from accessing the machine.
3. Make certain that the machine is connected to an adequate power source.
4. Do not use for any purpose other than lamination.
1. Width of upper and lower side of film should be same in order not to
allow melted adhesive resin to stick to the rollers.
2. Routine cleaning of rollers is required to prevent adhesive build-up .
3. Always keep the area around the machine clean.
To remove dust, finger prints, etc. from housing, use diluted alcohol
on lint-free cloth and do not permit liquids to get into laminator.
(Do not use strong alcohol or petroleum-based cleaning solvents or
abrasives.)
1. Owner's manual : 1
2. Roller cleaning papeer : (A3) 3 pcs
Symptom
* Motor doesn't work.
* Film is not laminated.
* Result of lamination
is not clear.
IMPORTANT SAFETY CONCERNS
MAINTENANCE
ASSEMBLY PARTS
TROUBLE SHOOTING
Cause
. Power cord may not be
plugged in.
. Power switch is OFF
. Cold mode may be set.
. Temperature on the
roller is too low or
laminating is too fast.
. Check the power cord.
. Check that the switch is on.
. Change the function to
hot lamination
. Increase temperature
or decrease speed.
17
Check point