Shoot Function Settings; C.fn: Setting Custom Functions - Quadralite NAVIGATOR X2 C Instruction Manual

Setting the Flash Trigger

SHOOT Function Settings

Press the <MENU> button to enter C.Fn SHOOT.
Press the <SET> button to choose one-shoot or multi-
shoots, and press the <MENU> button again to back to
the main menu.
One-shoot: When shooting, choose one-shoot. In the
M and Multi mode, the master unit only sends
triggering signals to the slave unit, which is suitable
for one person photography for the advantage of
power saving.
Multi-shoots: When shooting, choose multi-shoots,
and the master unit will send parameters and
triggering signals to the slave unit, which is suitable
for multi person photography. However, this function
consumes power quickly.
APP: Only send triggering signal when camera is
shooting (control the flash's parameters by
smartphone APP).
C.Fn Ver 9.2
SYNC
GROUP
LCD
APP
SHOOT
CLEAR
- 20 -
Setting the Flash Trigger

C.Fn: Setting Custom Functions

The following table lists the available and unavailable custom functions of this flash.
Custom Function Function Setting Signs
STBY Sleep ON
OFF
BEEP Beeper ON
OFF
MIN Power output 1/128
value 1/256
LIGHT Backlighting 12sec
time OFF
ON
SYNC Sync cord jack IN
OUT
GROUP Group 5 (A-E)
16 (O-F )
LCD Contrast ratio -3-+3
of LCD panel
Settings and Description
ON
OFF
ON
OFF
The minimum output is 1/128
The minimum output is 1/256
Off in 12 seconds
Always off
Always lighting
Enable Navigator X2 C to trigger flash
Export triggering signal to trigger other remote control
and flash
5 groups (A-E)
16 groups (0-F); 16 groups when the receiver end is
studio flash, which can only be set to M mode in this state
The contrast ration can be set as integral number from
-3 to +3
- 21 -