Westinghouse WHE6874 User Manual page 21

Replacing the Water Filter
To Remove: Pull cover towards you and cover
will drop down and allow access to filter.
To Reinstall: Push cover up towards liner and
then push towards rear of cabinet. Filter cover
will snap back into place.
It is not necessary to turn the water supply off to
change the filter. Be ready to wipe up any small
amounts of water released during the filter
replacement.
1. Ensure that the ice maker is turned off
2. Remove the filter by turning anti-clockwise
180˚
3. Slide the old water filter cartridge straight out
of the housing and discard it.
4. Unwrap the new filter cartridge and using the
alignment guide, slide it gently into filter
housing until it stops against the filter
connection at the back of the housing.
5. Engage the filter by firmly rotating clockwise
until the filter snaps into position (once
engaged the filter cannot be rotated further).
6. Press a drinking glass against the water
dispenser while checking for any leaks at the
filter housing. Any spurts and sputters that
occur as the system purges air out of the
dispenser system are normal.
7. After filling one glass of water, continue
flushing the system for about four minutes.
8. Turn on the ice maker.
9. When the filter has been replaced press and
hold the 'Reset Water Filter' button for
three seconds to reset the filter replace
timer.
10.Replace filter cover by pushing up and
snapping into place.
21