Connecting The Module To The Computer; Using The Found New Hardware Wizard - Mantracourt FSU-SSBD User Manual

Connecting the Module to the Computer

Connect to a USB port on the Windows PC using the cable provided with the module.

Using the Found New Hardware Wizard

Connecting the module will cause the following dialog windows to appear. NOTE: Different operating systems may
present different dialog windows but the dialogs shown below should allow you make the correct choices regardless
of operating system.
Note that the FSU shares the drivers with the DSC range of modules so the driver is described as
the USB DSC Bus.
The 'Found New Hardware Wizard' should now appear. Now the wizard will start searching for the drivers.
Select 'No, not at this time' if you are asked whether
the drivers should be searched for online.
Click 'Next'.
The wizard should then proceed with installing the
software drivers.
5 Mantracourt Electronics Limited – FSU User Manual