Table of Contents
Advertisement
Chapter 5: Operating Instructions
NOTE:
Port Parameter and Option Descriptions
Table 5-6
Parameter
Card-Type
The card type (Fiber/Cu) will be displayed.
NOTE:
Mode
The Mode parameter specifies the interface type used for the port interface. Values for
the Mode parameter are:
Disabled - This option disables the Port(s) on the Card.
Cu-CDI - This option sets the Combo Card to use the Copper CDI interface.
Fiber-CV - This option sets the Combo Card to use the optical port interface operating
"unframed" (CV mode). Use this option when the Port is connected to a CDI or
Manchester encoded (unframed) signal on the optical interface such as a CV-8448 or a
CV-FOM-D/CV-HTU-16M with its Fiber-Encoding parameter set to CV.
Fiber-FOM - This option sets the Combo Card to use the optical port interface
operating in a "framed" format compliant with JTC3A-9109C. Use this option when the
Port is connected to a framed signal on the optical interface such as a MD1272/G,
GSC-54, or a CV-FOM-D/CV-HTU-16M with its Fiber-Encoding parameter set to FOM.
Part No. 24001157
Revision C
Port-1, Port-2, Port-3 or Port-4
Selecting the Port-X (X=1,2,3 or 4) parameter displays a list Port parameters for
the selected port and their current values. The port parameters are:
•
Card-Type (Read-only).
•
Mode
•
Rate (Note that the Rate parameter does not appear when the
VersaMux is in Port Relay Mode)
•
OW-Filter (appears for the Combination Module Only)
Since a parameter value has an affect on the other parameters, we highly
recommend that you configure the port parameters in the order listed above
(Mode then Rate then OW-Filter).
Table 5-6
provides descriptions for the Port-X (1, 2, 3 and 4) parameters and
options.
Options and Description
Release 1.0 software supports only the Combo module as a user interface.
Table 5-6
VersaMux-4000 Operation & Installation Guide
(page 1 of 3)
Configure
Page 5-21
Advertisement
Chapters
Table of Contents
