Tatus Isplay Creens; Rf Input And Output Monitor Ports; A Mplifier S Hutdown - Advantech ARMA-C125-CRM Installation And Operating Manual

7.8 S D
TATUS ISPLAY
The front panel display allows an operator to view information on a number of critical operating
parameters. Use [é é ] and [ê ê ] keys to move between the various displays and sub-menus.
The following are typical status displays.
7.9 A S
MPLIFIER HUTDOWN
An amplifier can shutdown due to a FAULT or as a result of a hardware or software command.
A software shutdown is performed at either the front panel or by selecting the MUTE ON
function key sending the appropriate code via the RS-485 serial interface (see Section 6.3.2 at
page 24). The amplifier can be restarted in a similar manner provided a hardware shutdown is
not in effect. The amplifier can also be restarted by powering off & on the PA.
When the amplifier resumes operation, the attenuation level will return to its previous setting
after about 2 minutes of stable operation. Note however that the amplifier will not restart if a
FAULT condition is detected.
7.10 RF I
NPUT AND
The input and output monitor ports on the front panel provide a means to measure input and
output signals (in dBm) using appropriate test equipment. The coupling loss, normally associated
with RF sample, must be added to the power level measured at the sample port in order to obtain
the proper value for input or output power level.
S
CREENS
STATUS: ____
REFL. PWR <nn.n dBm
STATUS: ____
OUTPUT PWR nn.n dBm
STATUS: ____
PA HOTSPOT nn.n °C
STATUS: ____
PA SHROUD
STATUS: ____
SUPPL CURR nn.n A
O M P
UTPUT ONITOR ORTS
nn.n °C
ARMA-C125-CRM
36