Add A New Event - Nexcom NANO 1190 User Manual

Chapter 3: Remote Service

7.1 Add a New Event:

Copyright © 2016 NEXCOM International Co., Ltd. All Rights Reserved.
1. Select a camera or local device from the tree list.
2. Click the "Add" button below the device list.
3. Select an Event from the table.
Motion Alarm:
Camera's motion detection, you must set the camera motion first.
Disconnect Alarm:
The camera connected is disconnected.
Schedule Trigger:
Trigger by schedule settings.
HDD Error Alarm:
Trigger alarm when recording fails, only local devices have this
event.
4. Click the "Add" button below Event Schedule List table.
5. Select the weekdays and time period to monitor for the event.
6. Set Alarm detailed parameters.
98
MVS 5200/5210/MVS 5210-R Series & NANO 1190 NVR User Manual