Source Names Setup; Source Levels Setup - B&K PT 3 series II Owner's Manual

Source Names Setup

From the factory, your Preamplifier Tuner will display source names that match those printed on the rear of the
Preamplifier Tuner and on the supplied remote. However, this menu allows you to change the displayed names to
match the actual sources used. If you do not want to change the names then skip this step. Note that the tuner
name cannot be changed.
From Remote
1 From setup menu:
­ V
or
2 SEL or ENTER
desired source
3
­ V
4
or
ˆ ‡
5
(BAL L) or (BAL R)
6 repeat 4-5
7 repeat 3-6
8 MENU

Source Levels Setup

This setup allows you to match the levels of your sources so that there are no large changes in volume as you
change from one source to another. This is for your convenience only and need not be performed unless you wish
to. You may use a SPL meter or your ear to adjust the levels. Note that the levels will depend not only on this
setting but also on the source material being played back. You may wish to use a test disc. Note that the only
setting permitted are 0 and -6dB.
From Remote
1 From setup menu:
­ V
or
2 SEL or ENTER
desired source
3
ˆ ‡
4
(BAL L) or (BAL R)
5 repeat 3-4
6 MENU
From Front Panel
From setup menu:
(TUNE +) or (TUNE -)
( ENTER)
U
(SOURCE) step to source
(TUNE +) or (TUNE -)
VOLUME KNOB
repeat 4-5
repeat 3-6
—
(PRESET) and (ENTER)
From Front Panel
From setup menu:
(TUNE +) or (TUNE -)
( ENTER)
U
(SOURCE) step to source
VOLUME KNOB
repeat 3-4
—
(PRESET) and (ENTER)
20
Action
move to source names
enter source names menu
select desired source for renaming
change blinking character
move to new character position
until all renaming complete
to rename additional sources
return to setup menu
Action
move to source levels
enter source levels menu
select desired source for level setup
set desired level
set additional source levels
return to setup menu
P/N 13010 REV 0005