Preparations; Operation; Switching On And Off - Gardenline GLH 692 User Manual

Preparations

1. Check the hedge: It must not be wet. Remove any foreign objects, such as wires or
planting sticks.
2. Check the hedge trimmer to ensure all screw fittings are securely seated and the
blade with double cutter
3. Fully extend the extension cord in loops so that you can pull it towards you from
behind when working.
4. The cable strain relief
disconnected when cutting: Form a loop with the last 30 cm of the extension cord.
5. Guide the loop through the cable feed-through
cable strain relief (see Fig. B).
6. Slowly pull the loop against the cable strain relief to tighten it. If the loop is not
taut, the cord may become loose and slip out when working.
7. Insert the mains plug
8. Insert the mains plug of the extension cord in a properly installed socket.

Operation

Switching on and off

WARNING!
Risk of injury!
The double cutter will continue to run for a short period of time after
switching the hedge trimmer off!
− Hold the hedge trimmer securely until the double cutter
comes to a standstill.
The hedge trimmer is fitted with a two-hand safety circuit. It works only when one
hand presses the switch on the guide handle
switch on the grip
1. Hold the hedge trimmer by the guide handle. If you are right-handed, use your
left hand. If you are left-handed, use your right hand.
2. On the protective cap
the protective cap
3. Put the protective cap nearby.
4. Ensure that the blade with double cutter
double cutter can be started safely.
4 is sufficiently sharp.
8 prevents the extension cord from being accidentally
in the extension cord connector.
7
.
1
, gently press on both sides of the locking mechanism for
6
5 , and pull the protective cap off forwards.
and over the hook for the
9
and the other hand presses the
2
is not touching anything so that the
4
Operation
15