Kaden Installer's Manual
Ducted Gas Heaters
2.4.6 Installation of Flashing
2.4.6.1 KU5 models
Flashing MUST BE fitted to ensure the ductwork is adequately weather protected.
Step 1. Fit side flashing using existing screws on
cabinet sides.
Silcone
Step 3. Slide top flashing with fold under flashing
rail. Once in place silicone along the
upstanding face of top flashing.
It is important to allow for sufficient slack in the ducting connected to the heater's pops, to allow
the heater to be moved out from the wall if required for servicing.
NOTE
2.4.6.2 KU3 & KU4 models
For installation of flashing refer to the instructions provided with the flashing kit.
KU315, KU320, KU325, KU415, KU420 & KU425 use Kaden Part No. 1621299
NOTE
KU330 & KU430 use Kaden Part No. 1621300
16
Step 2. Fit flashing rail using the existing screws
from the cabinet.
Step 4. Push the heater up against the wall and
secure side flashing to the wall.