Setting The Auxiliary Output - Siemens PAD-3 Installation, Operation And Maintenance Manual

5.1.2

Setting the Auxiliary Output

Switch 4 on the DIP switch determines how the auxiliary power operates.
The PAD-3 checks switch 4 only when powering up. If you change this switch, you must push switch SW2
momentarily to reset the unit to recognize the new switch setting.
ON
OFF
2 3 4
2 3 4
Figure 5-2. Setting DIP Switch 4
Switch 4 OFF:
Auxiliary Power Output always on.
5 6
Switch 4 ON:
Auxiliary Power Output will shutdown 30 seconds after an AC Power fault
and the unit is running on battery.
5 6
35