Optimizing Image Performance (Analog Input) - HP E243M User Manual

Optimizing image performance (analog input)

Two controls in the on-screen display can be adjusted to improve image performance: Clock and Phase
(available in the OSD menu).
NOTE: The Clock and Phase controls are adjustable only when using an analog (VGA) input. These controls
are not adjustable for digital inputs.
The Clock must first be set correctly since the Phase settings are dependent on the main Clock setting. Use
these controls only when the auto-adjustment function does not provide a satisfactory image.
Clock: Increases/decreases the value to minimize any vertical bars or stripes visible on the screen
●
background.
Phase: Increases/decreases the value to minimize video flickering or blurring.
●
NOTE: When using the controls, you will obtain the best results by using the auto-adjustment pattern
software utility provided on the optical disc.
When adjusting the Clock and Phase values, if the monitor images become distorted, continue adjusting the
values until the distortion disappears. To restore the factory settings, select Yes from the Factory Reset
menu in the on-screen display.
To eliminate vertical bars (Clock):
1. Press the
Control.
2. Select Clock and Phase.
3. Use the function buttons on the monitor front bezel that display up and down arrow icons to eliminate
vertical bars. Press the buttons slowly so that you do not miss the optimum adjustment point.
4. After adjusting the Clock, if blurring, flickering, or bars appear on the screen, proceed to adjust the
Phase.
To remove flickering or blurring (Phase):
1. Press the
Control.
2. Select Clock and Phase.
3. Press the function buttons on the monitor front bezel that display up and down arrow icons to eliminate
flickering or blurring. Flickering or blurring may not be eliminated, depending on the computer or
graphics controller card installed.
To correct screen position (Horizontal Position or Vertical Position):
Menu button on the monitor front bezel to open the OSD menu, and then select Image
Menu button on the monitor front bezel to open the OSD menu, and then select Image
Optimizing image performance (analog input) 25