Yaesu FTM-400XDR Operating Manual page 14

Name and Function of Each Component
Controller
Front
Œ
➀ VOL knob (
The volume will increase when the knob is turned in a clockwise direction and
decrease when turned in an counter-clockwise direction.
The upper end is for Band A use while the lower end is for Band B use.
➁ D/X key ( )
The communication mode changes each time this key is pressed for a short time.
Tip
Refer to Page 45 for the communication mode.
WIRES-X will start when this key is pressed for one second or longer.
➂ Touch panel display
➃ Band A DIAL knob (
• The frequency of the upper band in the dual band display can be adjusted.
The frequency will increase when the knob is turned in a clockwise direction and
decrease when turned in an counter-clockwise direction.
Press the knob to enable setting the operating band frequency in 1 MHz units.
Press the knob for one second or longer to enable setting the frequency in 5 MHz
units.
• In memory mode when the knob is pressed for one second or longer, if a tag
(name) is attached to the memory channel, the tag and frequency displays will be
reversed.
• This knob is also used to select the items during the set up and memory
operations, group monitor operations, etc.
➄ Power supply/LOCK switch (
Press this button for 2 seconds or longer to switch the power on and off.
The key lock can be engaged or released by pressing the button quickly while the
radio is turned on.
➅ DISP/SETUP key (
The display screen will change each time the button is pressed quickly.
Tip Refer to Page 20 for the display.
Press the button for one second or longer to display the set-up menu.
14

)
)
)
)
Ž
Application for FCC / IC
FCC ID: K6620345X40 / IC: 511B-20345X40


‘
’
“
”