Mitsubishi Electric AJ65SBT2B-64AD User Manual page 24

No. Name
Terminal
block for
7
analog input
signal
DIN rail hook A hook to mount the module to a DIN rail
8
L TER. (Line
Termination)
9
switch
*1 This LED may turn on for a moment when the power is turned on; though the
AJ 65SBT2B-64AD operates normally.
*2 When station number setting switch setting is changed while communication
is disconnected, the LED will start flashing irregularly.
*3 When using the user range setting 2 (-5 to 5V) in test mode, set "I" for the
offset/gain adjustment LED.
*4 The transmission speed is automatically set depending on the master
module setting; therefore, it does not need to be set on the AJ65SBT2B-
64AD side.
Table 3.1 Part names
A terminal block for connecting input signals
Terminal
CH V+
CH I+
CH COM
SLD
TEST
AG
FG1
This switch is turned on to enable the built-in terminating resistor.
This switch is used when the AJ65SBT2B-64AD is connected at the end
of the network.
Its factory default setting is off.
Description
Description
Terminals for connecting external input signal
cables and shielded twisted pair cables
A terminal for short in test mode
A ground terminal (spare) (For application, refer to
Section 6.2.)
A terminal for grounding to the protective ground
conductor
9