LG PRCKA0 Installation Manual page 13

Connection of the wires
2
. For connection to outdoor unit and to controller (Field supply) :
Pull the wires inside through the cable gland and close that's nut firmly in order to ensure a
good pull relieve and water protection.
3
. The wires require an additional pull-relief. Strap the wire with the support tie wrap.
Support
tie wrap
Nut of cable
gland
4
. For the wired remote controller wire and outdoor unit communication wire, remove the coat-
ing at the end of the wire to connect and use the ring type (Ø3) to connect to the terminal
block.
5
. Each wire have to pass the number of the cable gland mentioned below.
1 2 3 4 5 6
(Side view)
(Side view)
Ring type (Ø 3)
8
7
Control Kit Installation
Detail
No. Electric wire
①
POWER SUPPLY
②
FAN SIGNAL
③
Outdoor com.
④
Room thermistor
⑤
Pipe thermistor(In/Out)
⑥
Remote controller
⑦
EEV Kit
⑧
DRY contact
13
Cable insert