Using The 3D Glasses - InFocus IN119HDxa User Manual

Installation
For more
™
detailed
information,
please refer
to 3D glasses
user's guide.
16
English

Using the 3D glasses

1. To turn ON 3D glasses.
2. Verify that 3D content is being sent to the projector and
signal is compatible with projector specifications.
3. Turn on the "3D Mode" (Off/DLP-Link/IR - depending on
which type of glasses you are using) of the 3D projector.
The option is located in the "Display" section of the
projector OSD menu.
4. Turn on 3D glasses and verify image appears in 3D without
eyestrain.
5. If the image does not appear in 3D, please check 3D
device set up correctly to send out 3D image or not. Or
"SBS" mode should be turned on when input signal is 2D
1080i side-by-side. Repeat previous steps 1 ~ 4.
6. It may be necessary to use projector's "3D Sync. Invert"
option to optimize your 3D experience. The option is
located in the "Display" section of the projector OSD menu.
7. To turn OFF 3D glasses: Press the "Power" button and hold
until the LED switches off.
8. For more detailed information, please refer to the 3D
glasses user's guide, or manufacturer's Website.