Configuration Settings - Amana PTAC Service Instructions Manual

PROPER INSTALLATION

CONFIGURATION SETTINGS

7 BUTTON TOUCH PAD WITH DISPLAY
The control can be configured to operate a wide range of
options. The options listed below with the * are the factory
default settings. If these are acceptable, then the unit does
not require any additional configuration and is fully oper-
able. To configure the unit, first select the configuration
feature code setting and then an option code to change
from the factory default setting.
To enter configuration feature mode:
1. Press and hold the up and down
same time and press the OFF
a two (2) second time frame then release the
The display will indicate = = if the security code (con-
figuration code uL) has been previously set. The dis-
play alternates between = = and 00. Use the up and
down arrow keys to change 00 to the previously
selected security code.
NOTE: The control will not proceed to the next step
until the correct code is entered. The security code
step will be skipped if no code has been set or if it has
been set back to 00.
32
The display will indicate - -. Press the
time. The display will then alternate between C1 and 0.
To select a different configuration feature code,
press the HEAT
ration comes up. To scroll to a previously viewed con-
figuration codes press the COOL
Once you have scrolled to the correct feature, then to
select the option code for your desired configuration,
arrow keys at the
press either the up or down key
the options of the selected feature code.
key twice within
To exit configuration mode:
.
1. Press the OFF
mode will also exit if no keys are pressed for a pe-
riod of two (2) minutes.
key one
key until the desired configu-
key.
to scroll through
key. Configuration feature