Download Print this page

Amana PHB**C User's Information Manual

Heat pump package unit

Advertisement

RECOGNIZE THIS SYMBOL AS A SAFETY PRECAUTION
May 1999 (2)
PHB**C/PHD**C
To avoid death, personal injury or property damage, do not use this unit if
any part of the unit has been under water. Immediately call a qualified
service technician to inspect the unit and to replace any part of the
control system.
You have purchased a heat pump package unit. It is approved for an
outdoor installation only and is designed to provide many years of safe and
dependable service with proper installation, use, and maintenance. Take
time to familiarize yourself with the information concerning unit installation,
features, operation, and maintenance contained within this manual. Refer to
the Specification Sheet for the needed clearance around the unit.
Please take the time to fill out your owner's registration card and mail it
today. This will assist Amana in contacting you should any service or war-
ranty information change in the future. When filling in the registration card,
be sure to include the Model, Manufacturing and Serial Numbers, plus the
installation date. If the registration card cannot be located, please call 1-800-
843-0304 to register the unit.
Your warranty certificate is also supplied with the unit. Read the warranty
carefully and note what is covered. Keep the warranty certificate in a safe
place, so you can find it, if necessary. Before using this manual, check the
serial plate for proper model identification.
Installer - Affix this manual, the Installation Guide, and Specification Sheet
adjacent to the appliance.
Owner
- Keep all product literature in a safe place for future reference.
Due to policy of continual product improvement, the right is reserved to
change specifications and design without notice.
THE INSTALLATION AND SERVICING OF THIS
EQUIPMENT MUST BE PERFORMED BY QUALIFIED,
EXPERIENCED TECHNICIANS ONLY.
Heat Pump Package Unit
User's Information Manual
WARNING
®
10500211

Advertisement

loading

Summary of Contents for Amana PHB**C

  • Page 1 Specification Sheet for the needed clearance around the unit. Please take the time to fill out your owner’s registration card and mail it today. This will assist Amana in contacting you should any service or war- ranty information change in the future. When filling in the registration card, be sure to include the Model, Manufacturing and Serial Numbers, plus the installation date.
  • Page 2: General Information

    General Information WARNING To avoid death, personal injury, property damage or equipment damage, the following instructions must be observed regarding unit location, clearances, air requirements and operating procedures. Certain mechanical and electrical skills and tools are required to properly perform maintenance on the unit. Personal injury or death may result if installed or serviced by unqualified persons.
  • Page 3 Keep the blower access door and access panel in place except for inspection and maintenance. Compressor Protection Devices The PHB**C and PHD**C compressors include components which are designed to protect the compressor against abnormal operating conditions. These components do not affect the operation of the indoor blower.
  • Page 4: Routine Maintenance

    Operating Instructions CAUTION This unit must not be used as a “construction heater” during the finishing phases of construction on a new structure. This type of use may result in premature failure of the unit due to extremely low return air temperatures and exposure to very dirty atmospheres.
  • Page 5: Any Questions

    Any Questions? Most of your questions can be answered by your local Amana dealer. Check with your dealer first if you need any further information regarding the operation, maintenance, or service of your unit. Then, if you should have any matters...

This manual is also suitable for:

Phd**c