Cutting A Hole And Mounting Installation Plate - Toshiba MMK-AP0057HP-E1 Installation Manual

5
CUTTING A HOLE AND MOUNTING INSTALLATION
PLATE
Cutting a hole
In case of installing the refrigerant pipes from the
rear:
1. Decide the hole position for piping at
180mm from the arrow mark ( ) on the
installation plate and drill a hole at a slight
downward slant toward outdoor side.
The center of the pipe
hole is above the arrow.
NOTE
• When drilling a wall that contains a metal lath,
wire lath or metal plate, be sure to use a pipe
hole brim ring sold separately.
Mounting the installation plate
Hook
Pipe hole
Indoor unit
15-EN
Pipe hole
Ø65 mm
120 mm
110
Hook
Hook Installation
plate
Thread
Pipe hole
5 Mounting screw
Weight
When the installation plate is
directly mounted on the wall
1. Securely fit the installation plate onto the
wall by screwing it in the upper and lower
parts to hook up the indoor unit.
2. To mount the installation plate on a
concrete wall with anchor bolts, utilize
the anchor bolt holes as illustrated in the
above figure.
3. Install the installation plate horizontally in
the wall.
When installing the installation plate with a
mounting screw, do not use the anchor bolt
hole. Otherwise the unit may fall down and
result in personal injury and property damage.
NO OK
GOOD
5mm dia. hole
148
Clip anchor
(local parts)
1
Failure to firmly install the unit may result in
personal injury and property damage if the unit
falls.
• In case of block, brick, concrete or similar type
walls, make 5mm dia. holes in the wall.
• Insert clip anchors for appropriate mounting
screws.
NOTE
• Secure four corners and lower parts of the
installation plate with 6 mounting screws to
install it.
‒ 15 ‒
Installation Manual
CAUTION
NO
Anchor bolt
GOOD
Projection
15mm or less
Mounting screw
4 × 25R
CAUTION