Battery - Toshiba MMK-AP0057HP-E1 Installation Manual

Installation diagram of Indoor and outdoor units
Before installing the
wireless remote controller
1. Remove the battery
cover.
2. Insert 2 new batteries
(R03 [AAA] type)
following the (+) and (−)
positions.
Wireless
remote controller
Cover
Batteries
Batteries
Pan head
wood screw
Remote control holder
Installation space
The indoor unit shall be installed so that its top surface comes at a height of 2.5m or more.
Also it must be avoided to put anything on top of the indoor unit.
*1 Reserve space required to install the indoor unit and for service work.
Keep 110mm or more for clearance between top plate of the indoor unit and the ceiling surface.
*2 Provide a space as shown for service clearance for the cross flow fan.
Installation place
• A place which provides the spaces around the indoor unit as shown in the above diagram.
• A place where there is no obstacle near the air inlet and outlet.
• A place that allows easy installation of the piping to the outdoor unit.
• A place which allows the front panel to be opened.
• Direct sunlight to the indoor unit's wireless receiver should be avoided.
• The microprocessor in the indoor unit should not be too close to RF noise sources.
(For details, see the owner's manual.)
13-EN
Insulate the refrigerant pipes
separately with insulation, not
Wireless
together.
remote controller
Hook
Installation
plate
1
Shield pipe
6 mm thick heat resisting
polyethylene foam
CAUTION
‒ 13 ‒
Installation Manual
For the rear left and left piping
Wall
Insert the cushion between the
indoor unit and wall, and tilt the
indoor unit for better operation.
Do not allow the drain hose to get
slack.
Cut the piping
hole sloped
slightly.
Make sure to run the drain hose
sloped downward.
The auxiliary piping can be
connected to the left, rear left, rear
right, right, bottom right or bottom
left.
Right
Rear right
Left
Rear
Bottom
right left
Bottom left