Van Walt YSI Pro Plus Quick Start Manual

VAN WALT
Monitoring your needs
QUICK START GUIDE:
This guide serves as a quick reference
for operating a YSI Pro Plus. It is for
your convenience & not intended to
replace the full-length manual where
additional information may be found.
Van Walt Ltd | Prestwick Lane | Grayswood | Haslemere | Surrey | GU27 2DU | Tel. 01428 661 660 | Fax. 01428 656 808 | www.vanwalt.com
RR102V6_07/06/2018_JI
YSI Pro Plus Water Quality Meter
This unit was calibrated on the day we sent it to you. (See Calibration Certificate)
1. Attach the Quattro Cable to the YSI meter.
2. Remove calibration cup & attach probe guard or flow cell over probes.
a. If using probe guard, carefully & slowly lower the probe end of the
cable to required height in the well.
b. If using the flow cell, attach to pump & begin to pump sample
through the flow cell. Please ensure that the Flow Cell is kept up
right by using our Van Walt base plate located in the Peli case, will
cause inaccurate readings if left horizontal.
3. Green button to turn on/off meter.
4. Press: PROBE -> DISPLAY to show desired sensor reading on screen. Allow 5 -
10 minutes for DO probe to warm up.
Logging
1. Press: FILE -> SITE LIST -> ADD NEW to create personal site.
2. Press: SYSTEM -> LOGGING -> CONTINUOUS MODE to begin automatic
interval logging.
3. Press: ENTER to begin logging.
4. Press: SITE in drop down menu to select your personal site.
5. Pres: ENTER to stop logging.
6. Press: FILE -> VIEW DATA to view data.
+44 (0)1428 661 660