Van Walt YSI Pro DSS Quick Start Manual

QUICK START GUIDE: YSI Pro DSS Water Quality Meter
This guide serves as a quick reference
for operating a YSI Pro DSS. It is for
your convenience & not intended to
replace the full-length manual where
additional information may be found.
Van Walt Ltd | Prestwick Lane | Grayswood | Haslemere | Surrey | GU27 2DU | Tel. 01428 661 660 | Fax. 01428 656 808 | www.vanwalt.com
RR182V5_07/07/2023_TD
This unit was calibrated on the day we sent it to you. (See Calibration Certificate)
1. Attach the cable to the YSI meter.
2. Remove calibration cup & attach flow cell over probes if required.
a. Where probe guard is used, carefully & slowly lower the probe end of
the cable to required height in the well.
b. If using the flow cell, attach to pump & begin to pump sample
through the flow cell. Please ensure that the Flow Cell is kept up
right by using our Van Walt base plate located in the Peli case, will
cause inaccurate readings if left horizontal.
3. Green button to turn on/off meter.
4. Press: PROBE -> DISPLAY to show desired sensor reading on screen.
Logging
• Press Enter to start logging and add details
• Select: Log interval -> Enter Value
• Select: Site -> Add New -> Enter details and save
• Select: Data ID -> Add New -> Enter details
• Select: Start now! to begin logging
• Press Enter to stop logging
+44 (0)1428 661 660