Parts List - Windsor PowerTec 28 Owner's Manual

PARTS LIST

NO.
KEY PART DESCRIPTION
531 77
1
2 Brushes, Carbon Replacement
3 35087 Gasket, 5.7 Vac Motor
4 08040 Base, Vac Motor Mounting
5 35089 Gasket, Vac Base Seal
8701 3 Washer, 114 ID
6
7 70360
Float Asm, VAc Shut-Off
8 341 59
9 571 05 Nut, 1/4-20 w/ Star Washer
Screw, All Thread 1 /4-20
10 671 71
Connector,
11 76083
12 76085 Terminal, 14/10 Ga.
13 53718 Motor Asm, (Items 1, 11,12)
4
Remove and Allow to Dry
Items 1,3, & 8 should be set aside at the
end of each work day and allowed to dry.
Never run the machine without item
place. For the best vacuum performance, be
sure items 1,3, & 4 form a good seal.
POWERTEC 28/34
x
5/8 OD SS
Plug
Housing Socket
11 & 1 2
6
8
in
Wire Terminal
Important:
Replace carbon vac mo-
tor brushes if worn
down to 3 / 8 in length.
These brushes wear
quicker as the length
shortens due to in-
creased heat.
Spring inside brush
housing will damage
motor if brushes are
allowed to completely
wear away.
Note:
Place
stop in
groove.
At the end of each work period, with
1.)
the machine off, disconnect the motor
leads (Items 9 & lo), and remove the
2.) Clean the Vac shut-off (item 8) at the
end of each work period.
Allow to dry.
3.)
Periodically check the length
carbon brushes (item 2). Replace carbon
brushes which are
Important:
carbon vac
I 1
I
motor brushes
loosen wire
terminal
BEFORE
removing screws
on
bracket.
of
the
less 3 / 8
than long.
7