Windsor PowerTec 28 Owner's Manual page 17

MECHANICAL CONTROLS PARTS LIST:
23 41 150 Handle. Squeegee Lift
Linkage. Sa ueeaee Frame Pivot
24 51137
25 51135
27 70305 Screw. 511 6
crew. 1/4
POWERTEC 28/34
CAUTION:
Do not use pressure washers to clean
sealed gearboxes or bearings.
If it
machine with a pressure washer; Ensure
all items noted are re-lubricated.
Cleaning Solution
The travel of the solution lever should be
smooth. When it becomes difficult to
move the solution lever it may be neces-
sary clean and lubricate the cable by
spraying a cable lubricant down into the
cable housing.
Stiffener Adjustments:
Part numbers 26, 25,35, and
factory set adjustments which control
vibration. Over the course of time it may
become necessary to adjust these items.
Disconnect one end and adjust by turning.
50
51
52
Rod Ac4j.W
18 x 314 HHCS
55
x
20 1/2 HHCS
56
becomes necessary to clean under
73526 Scrub Deck. PT34
Screw. 1 /2- 13 x 1.50 H-HCS
70340
70368 Screw, 3/8-16 x 1 314 HHMS
Washer. 3/8 In x 710 OD
87003
Wheel, Bumper
Bushina. .75 OD x .50 ID fla.
70361 Screw, 10-32 x 1/2 PHTR
are
34
17