Related Manuals for Wavtech linkD
Summary of Contents for Wavtech linkD
- Page 1 2-Channel LOC / Line Driver 10Vrms Output Ÿ Auto Turn-On OEM Load Detect Compatible Ÿ Owner’s Manual www.wavtech-usa.com...
- Page 2 This symbol means important instructions. WARNING Failure to heed them can result in serious injury or death. This symbol means important instructions. CAUTION Failure to heed them can result in injury or property damages. WARNING • DO NOT DRIVE WHILE DISTRACTED. Any function that requires your prolonged attention should not be performed while driving.
- Page 3 CAUTION • STOP USE IMMEDIATELY IF A PROBLEM OCCURS. Failure to do so may result in personal injury or damage to the product. Return it to your authorized Wāvtech dealer. • HAVE AN EXPERT DO THE WIRING AND INSTALLATION. This unit requires special technical skill and experience for wiring and installation.
- Page 4 Connections & Functions ΠPower Indicator: This red LED indicates when the linkD is powered on. Once illuminated, there will be a short delay before audio signal output is enabled. During initial power connections, the LED may illuminate for a brief period.
- Page 5 Input signals ranging from 2Vrms to 20Vrms will produce up to 10Vrms RCA output from maximum to minimum gain. For factory amplifiers with more than 20Vrms signal or if the linkD’s output is too high for the connected aftermarket amplifier(s) with all gains at minimum, internal jumpers are available to reduce the input sensitivity range by half (-6dB) for 4Vrms up to 40Vrms.
- Page 6 +12V only when turned on), connect it to the REM IN terminal. If a remote lead is unavailable, the linkD also has an auto turn-on circuit that simultaneously detects audio signal from SPK and AUX inputs as well as DC-offset from SPK inputs.
- Page 7 Note: When using a receiver’s internal power IC to drive speakers directly and provide the linkD with signal, note that its speaker outputs will likely clip before reaching the maximum volume setting. Adjust gain settings accordingly for optimum unclipped volume range.
- Page 8 Note: When using a receiver’s internal power IC to drive speakers directly and its RCA outputs to the linkD for external amplifiers, note that speaker outputs will usually clip at a lower volume level than RCA outputs. Adjust gain settings accordingly for matched unclipped volume range.
- Page 9 Specifications Max Flat (+0/-1dB) <10Hz to >75kHz Frequency Response Extended (+0/-3dB) <10Hz to >100kHz Spk Input 180Ω Input Impedance RCA Input 20kΩ Spk Input (max-min gain) 2-20Vrms / 4-40Vrms Input Sensitivity RCA Input (max-min gain) 0.5-5Vrms Max Input Voltage 40Vrms Spk Input peak, <5sec cont.
- Page 10 (size/location, etc.) Subwoofer(s) Ÿ (size/location, etc.) Amplifier(s) Ÿ (location, output voltage, etc.) Other: Ÿ linkD Connections & Settings Installed Location: Ÿ Wiring Ÿ (connection locations, signal type, turn-on mode, etc) Level Settings Ÿ (gain position, max master vol, etc.) Other: Ÿ...
- Page 11 Warranty & Service Care Wāvtech warrants this product to be free from defects in material and workmanship for a period of one (1) year when purchased from an authorized Wāvtech retailer within the United States. This warranty will be extended to a period of two (2) years when the installation is performed by an authorized Wāvtech retailer.
- Page 12 v0518 Wāvtech™ 7931 E. Pecos Rd Suite 113 Mesa, AZ 85212 (480) 454-7017 ©Copyright 2018 Wāvtech, LLC. All Rights Reserved.