Page 1
RESTOR Bass Restoration Processor / LOC / Line Driver Complete Tuning Control Ÿ Auto Turn-On Ÿ Multi-Function Remote Owner’s Manual www.wavtech-usa.com...
Page 2
This symbol means important instructions. WARNING Failure to heed them can result in serious injury or death. This symbol means important instructions. CAUTION Failure to heed them can result in injury or property damages. WARNING • DO NOT DRIVE WHILE DISTRACTED. Any function that requires your prolonged attention should not be performed while driving.
Page 3
“ Mounting Tabs: These mounting tabs are pre-attached and should be used to properly secure the bassRESTOR during installation with screws or cable ties. They are removable if the unit can be safely secured by another method. ”...
REM IN or signal sensing, and will provide over 500mA of constant current for external devices. Remote Level Control (RLC): Connect the remote to the bassRESTOR’s RLC port with the supplied 16.4ft/5m cable. Plan cable routing before mounting the remote to ensure proper length. If additional length is required, a standard 8-conductor CAT5 or CAT6 ethernet cable or extension may be used.
Page 5
REM OUT Note: If the source’s output signal is full-range and the bassRESTOR is being used for subwoofer(s) only, a low-pass filter will need to be engaged at the amplifier to filter out unwanted higher frequencies. Additionally, unless the amplifier already has an adequate subsonic filter, set the bassRESTOR’s subsonic filter appropriately to prevent over-excursion.
Remote Adjustments Œ Bass Restoration On/Off: By short pressing the main knob, the bass restoration circuit can be activated or completely bypassed. This function provides quick ability to defeat the effect for music content that already has enough bass without changing the bass effect level setting from the outer ring.