Download Print this page

Wavtech bassFREQ Owner's Manual

Bass processor, loc. line driver, parametric eq 24db/oct crossover remote level control

Advertisement

Quick Links

Bass Processor / LOC / Line Driver
Parametric EQ Ÿ 24dB/Oct Crossover Ÿ Remote Level Control
Owner's Manual
www.wavtech-usa.com

Advertisement

loading

Summary of Contents for Wavtech bassFREQ

  • Page 1 Bass Processor / LOC / Line Driver Parametric EQ Ÿ 24dB/Oct Crossover Ÿ Remote Level Control Owner’s Manual www.wavtech-usa.com...
  • Page 2 This symbol means important instructions. WARNING Failure to heed them can result in serious injury or death. This symbol means important instructions. CAUTION Failure to heed them can result in injury or property damages. WARNING • DO NOT DRIVE WHILE DISTRACTED. Any function that requires your prolonged attention should not be performed while driving.
  • Page 3 Use quality interconnects to ensure stable connection and minimize the possibility for induced noise. “ Mounting Tabs: These mounting tabs are pre-attached and should be used to properly secure the bassFREQ during installation with screws or cable ties. They are removable if the unit can be safely secured by another method.
  • Page 4: System Examples

    Example-2: Speaker Level Input from OEM Amplifier +12V RCA OUT SPK IN REM OUT Note: In vehicles where the factory radio has a fixed level or digital output to a factory amplifier, signal for the bassFREQ’s speaker level input should be connected at the amplifier’s output.
  • Page 5 Note: Other devices such as smartphones or MP3 players may also be used as the main system source via the RCA input, which typically produce 1Vrms output or less. While the bassFREQ’s auto turn-on circuit will detect very low signal levels, it may be necessary in some cases to adjust gain for reasonable listening levels but with reduced master volume range.
  • Page 6: Specifications

    ’ Crossover: This section is for selecting the cut-off frequencies for the low-pass filter (LPF) and subsonic filter (a.k.a. infrasonic or high-pass). “ Subsonic: Provides adjustment of the lower cut-off point, below which all frequencies are filtered out at -24dB/Oct. Very low freqencies can waste amplifier power and damage subwoofers. This adjustment is especially important for ported enclosures to prevent over-excursion below the tuning frequency.
  • Page 7: Installation Notes

    Ÿ (size/location, etc.) Subwoofer(s) Ÿ (size/location, etc.) Amplifier(s) Ÿ (location, output voltage, etc.) Other: Ÿ bassFREQ Connections & Settings Installed Location: Ÿ Wiring Ÿ (connection locations, signal type, turn-on mode, etc) Settings Ÿ (gain, max master vol, crossover, etc.) Other: Ÿ...
  • Page 8 Wāvtech™ 7931 E. Pecos Rd Suite 113 Mesa, AZ 85212 (480) 454-7017 ©Copyright 2017 Wāvtech, LLC. All Rights Reserved.

This manual is also suitable for:

Linkd