Leveling Adjustment - Sawmaster T7 Owner's Manual

T7 • Owner's Manual
3. After adding shim(s), mount the table onto the guide
a r s l i a n d e r a g i l n h t e
Check to see if any shifting persists. A shift tolerance of
0.2mm is allowed. A shift in excess of that will require
further adjustment—repeat step 1.

LEVELING ADJUSTMENT

This procedure levels the table so that it is perpendicular to
the blade and flush against the rails.
1. Loosen the socket bolts on the flat roller plate so that the
roller can swing freely about the bolt. (see figure 11)
Do this for both flat roller plates.
Flat rollers rotate in this manner
2. Hold the table against the guide rails. The flat rollers
should reposition themselves to maintain contact with
the guide rails. If the table is not perpendicular to the
blade, lift the right side of the table instead to obtain the
proper angle. A square tool will be required to confirm
the angle. Tighten the socket bolts. Check the table for
play. Repeat step 1-2 if some play is still present.
13
a t b e l o t h t e b a l d e u s n i g m e h t o d . 1
figure 11