Page 1
CONTRACTOR SERIES SmartSequencer ™ CN-1800S and CN-2400S Command Set / Protocol Specification CN-1800S UNSWITCHED DELAY 1 DELAY 2 DELAY 3 120VAC, 50/60/HZ REMOTE PORT SMARTSEQUENCING FORCE OFF 15A MAX +12V COMM/ STAT POWER DELAY 3 CLASS 2 WIRING CN-2400S 120VAC, 50/60/HZ...
Comm. System: Asynchronous, half-duplex The purpose of this document is to outline the command set used to communicate with and control the Furman Contractor Series of products. The data communication feature will Baud Rate: 19,200bps most often be used to interface with automation systems. It may also be used to control and configure the unit manually using a standard terminal emulation program (i.e.
Page 3
Provides an enumerated list of all sequencers connected to the Command: !EVENTS_ENABLE sequencer <CR> Primary Sequencer. 3.5.1 3.2.3 Response: For an individual sequencer: $ACK 0,CN-1800S,LAST <CR> sequencer= {0..n} For a group of n sequencers: $ACK 0,CN-1800S<CR> Example: !EVENTS_ENABLE 9<CR> (Enables Events on sequencer 9) $ACK 1,CN-2400S<CR>...
Page 4
Response: $ACK sequencer VOLTAGE=118.3 4.5.2 Response: $ACK sequencer, ID <EOT> FURMAN -> Brand CURRENT CN-1800S -> Model Requests the AC current (in Amps) measurement on the sequencer specified by sequencer. The sequencer number must be provided. 12345678901234 -> Serial number 4.1.1 Query: ?CURRENT sequencer <CR>...
Page 5
Example: ?STATUS 3<CR> (get status data from sequencer 3) 4.9.2 Response: $ACK sequencer, (model) LAST <CR> For a chain of n units: Response: $ACK sequencer, STATUS 4.7.2 $ACK 0,CN-1800S -> Primary unit SEQ=PRIM,LAST > Sequencer position $ACK 1,CN-2400S -> Secondary unit PROTECT=OK ->...