Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Furman PWRLINK
Summary of Contents for Furman PWRLINK
- Page 1 PowerLink REMOTE AC POWER SEQUENCE CONTROLLER AC POWER SEQUENCING...
-
Page 2: Quick Start
POWERLINK REMOTE AC POWER SEQUENCE CONTROLLER QUICK START The illustrations below show several of the most common hookup methods for the PowerLink. There are many other methods and features, however, so please refer to the rest of this manual for more details if necessary. - Page 3 POWERLINK REMOTE AC POWER SEQUENCE CONTROLLER INTRODUCTION Congratulations on your purchase of a Furman PowerLink Remote AC Sequence Controller. Please read this manual completely before installing your PowerLink. FEATURES Allows you to trigger six power con- trol devices in a sequenced fashion Six circuits, each with a front panel ...
- Page 4 POWERLINK REMOTE AC POWER SEQUENCE CONTROLLER DESCRIPTION The Furman PowerLink is a compact, low-cost rackmount Remote Sequencer that provides timing for up to six power control devices, turning them on and off in a preset seq uence. The delay interval between the turn-on or turn-off of each device and the next in sequence is user- adjustable via an internal trimpot.
- Page 5 POWERLINK REMOTE AC POWER SEQUENCE CONTROLLER note that in the absence of any signal applied to the remote input, the REM position defaults to on. (If the PowerLink has been changed from the factory- preset Maintained Mode to Momentary Mode, you must also press the START ON/OFF SEQUENCE button.
-
Page 6: Remote Operating Modes
REM input to keep the PowerLink’s circuits off, when the key switch is in the REM position. This mode is compatible with all other Furman power products’ REM inputs. Internal jumpers allow selection of either of two other optional modes, as described below. Please... -
Page 7: Setup For Remote Operation
PowerLink’s remote operation. Main- tained switches, such as most toggle switches and push-on/push-off button switches, and includ- ing the Furman RS-1 wall mount key lock switch, are open until actuated, then stay closed until actuated again. Momentary switches, including... - Page 8 LED does not light when the switch is in the ON position, check the polarity and reverse the LED leads if it is wrong. If a Furman RS-1 is the controlling switch, contact Furman’s Tech Support department for the proper wiring diagrams. The...
-
Page 9: Multiple Units
POWERLINK REMOTE AC POWER SEQUENCE CONTROLLER 10 mA. If you wish to use the STATUS output as a voltage signal to some monitoring device, and also wish to light a status LED on a remote panel, put a 1 K Ohm 1/4-watt resistor in series with the LED. - Page 10 (Other Furman products blink one of their status lights to indicate the remote status.) Because the remote control inputs are optically isolated, they have a separate “ground”...
-
Page 11: Limited Warranty
Furman. This warranty applies only to the original owner and is not transferable. Also, it does not apply to repairs done other than by the Furman factory or Authorized Repair Stations. This warranty shall be cancelable by Furman at... -
Page 12: Specifications
(4.4 x 48.3 x 18 cm) Construction: Steel chassis, zinc chromate plating; .125” brushed and black anodized aluminum front panel. Safety Information: All current-carrying components are UL/CSA listed. Furman Sound, Inc. 1997 South McDowell Blvd. Petaluma, California 94954-6919 USA Phone: 707-763-1010 Fax: 707-763-1310 Web: www.furmansound.com E-mail: info@furmansound.com...