Table of Contents
Advertisement
Refer to the manufacturer's instructions of the robot mower for the technical specifications for
installation of perimeter wire.
Initially, attach the end of the wire to a stake or a tool planted in the ground.
1) Start the engine and open throttle fully;
2) Lift the support foot in front the machine;
3) Slowly insert the blade into the ground by pressing down on the handle until the frame is parallel
to the ground
(Figure 1);
4) Apply pressure to the traction handle to move the machine
(Figure 2).
3.5 Inserting the Derimeter wire in the wire ~uide
Proceed as follows:
1) PuIl the end of the wire from the spool
(Figure 1);
2) insert the wire in the wire deflector
(Figure
2,
A)
and in
the hole in the chassis
(Figure
2, 8);
3) Insert the wire in the guide wire tube until it emerges
(Figure 3).
3.6 Burying the perimeter wire in the ground
13
Advertisement
Table of Contents
