Moving The Machine To The Working Zone; Using The Distance Guide; Self-Propulsion - Perimeter PWM600MH User Manual

3.2 Moving the machine to the working zone
To move the machine to the working zone:
1) Loosen the clamping lever on the handle;
2) Pivot the handle until it is vertical on the machine;
3) Lift the support foot in front the machine;
4) Puli or push the machine to the work area.
3.3 Using the distance guide
Perimeter wire machine PWM600MHTM
is equipped with an adjustable
distance guide. This is used to align the machine with the edge of the
course and bury the wire at a distance between 15 cm and 45 cm.
To use the distance guide:
1) Unscrew the wing nut (see
A);
2) Position the distance guide at the desired distance according to
the ruler label. The ruler allows positioning between 15 and 45
cm to the nearest centimetre.
(See B);
3) Tighten the wing nut.
3.4 Self-propulsion
The
PWM600MHTM Perimeter Wire Machine
is equipped with a
transmission for self-propulsion. This allows for a constant rate of
installation and considerably reduces operator effort.
To engage it, simply apply pressure to the traction handle
(see Figure).
~CH
12