Rosen ClearVue CV6825 Owner's Manual page 8

Operating the System
The system comes with two wireless IR headphones that receive a
signal from the IR transmitter dome near the overhead console.
Volume
Power LED
To turn the headphones on and off, push the Power ON/OFF
button on the right ear piece. The Power LED on the left ear piece
indicates when headphone power is on. Power shuts off
automatically after 3 minutes of no audio to preserve battery life.
To adjust the headphone volume, rotate the thumb wheel switch on
the headphones.
The wireless IR headphones require two AAA batteries. To replace
the batteries, remove the battery compartment cap on the right
earpiece and insert batteries, as shown.
Page 7
Power ON/OFF
Rosen Products
Using the Car Speakers
To listen to system audio through your car speakers:
1 Power on system.
2 Insert a video cassette tape.
3 Turn on the car radio.
4 Tune the car radio to the FM frequency 88.7; this is the default
system frequency.
If audio from the system does not play over the car speakers:
1 Press SPEAKER ON/OFF on the remote control until "FM ON"
appears on the screen.
and /or
2 Tune the radio to 89.1 FM. This is an alternate system fre-
quency.
To turn off audio over the car speakers, press SPEAKER ON/OFF
on the remote. Audio from the system is then available over the
headphones only.
Note: Leaving the system to SPEAKER ON mode will reduce the
performance of normal radio reception. To receive the
best reception, always turn the system to SPEAKER
OFF when not in use.
Using the TV Tuner
To view television:
1 Power on the system.
2 Press MODE on the remote control until "CH __" appears on
the screen where __ is the current channel ("CH 2" for ex-
ample).
3 Press PREV TRK or NEXT TRK on the remote to change
channels.
Note: Broadcast television reception varies with location, terrain,
distance from the broadcast tower, and other factors. Signal
quality is likely to vary in a moving vehicle.
ClearVue 6825 VCR System Owner's Manual
Operating the System
Page 8