Information Codes - Samsung MS32J5133B Series User Manual

Problem
Turntable
While turning, the There is no roller ring,
turntable comes or the roller ring is not
out of place or properly in place.
stops turning.
The turn table The roller ring is not
drags while properly in place, there
turning. is too much food, or the
container is too large and
touches the inside of the
microwave.
The turn table Food residue is stuck to
rattles while the bottom of the oven.
turning and is
noisy.
note
If the above guidelines do not enable you to solve the problem, then contact your
local SAMSUNG customer service centre.
Please have the following information read;
• The model and serial numbers, normally printed on the rear of the oven
• Your warranty details
• A clear description of the problem
Then contact your local dealer or SAMSUNG aftersales service.
MS32J5133BT_SA_DE68-04325B-01_EN.indd 33
Cause Action
Install the roller ring and then
try again.
Adjust the amount of food and
do not use containers that are
too large.
Remove any food residue
stuck to the bottom of the
oven.

Information codes

Code Description
Control buttons
C-d0 are pressed over
10 seconds.
Cooking sensor is
C-10
needed to check.
note
If the suggested solution does not solve the problem, contact your local SAMSUNG
Customer Care Centre.
Action
Clean the keys and check if there is water
on the surface around key. If it occurs
again, turn off the microwave oven over
30 seconds and try setting again. If it
appears again, call your local SAMSUNG
Customer Care Centre.
Press the Stop/Cancle button and operate
again. If it occurs again, turn off the
microwave oven over 30 seconds and try
setting again.
If it appears again, call your local
SAMSUNG Customer Care Centre.
English 33
2015-11-05 1:45:56