Table of Contents
Advertisement
DOOR PANEL ASSEMBLY
91A
NOTE: NUTS AND BOLTS (SUPPLIED) MAY BE USED
INSTEAD OF POP RIVETS (SUPPLIED) BY SIMPLY
ENLARGING THE HINGE HOLE SETS IN THE JAMB
USING A 4MM DRILL BIT
NOTE: The two holes required to connect the padbolt hasp for each door have not been pre-punched, to allow for
proper alignment. position each hasp centrally over the padbolt shaft, and drill 3mm holes and secure with screws
ABSCO INDUSTRIES
Absco Space Saver Shed
Model: 15151S
91A
B
ASSEMBLY INSTRUCTION - MODEL: 15151S 15/01/13
B
PAGE 14
Advertisement
Table of Contents
