SImx LED MAX Installation Instructions

INSTALLATION INSTRUCTIONS
Model: 2x 8 Watt Sensor LED MAX
Thank you for purchasing this SIMX sensor light. This light is suitable for both ceiling or wall installation
and sheltered outdoors. It requires a 220~ 240V AC power supply.
Please read this manual thoroughly before installation and retain for future reference.
LHT0269 Black
LHT0270 White

TECHNICAL SPECIFICATIONS

Detection range: 8 ± 2 m
Detection Angle:
140° at 3 metres; 90° at 8 metres
Time setting: min 20 sec ± 40 sec
max 4 min ± 7min
Dusk control: Day to night (adjustable)
PIR Aiming adjustment: Pan only, left 90° & right 90°
!
IMPORTANT
This product is suitable for use only with a supply voltage of 220-240V AC 50Hz.
All electrical work must be carried out in accordance with local and national electrical codes as applicable.
We strongly recommend that this light fitting is installed by a registered electrician.
Always switch power off prior to installation. A means of mains power isolation must be installed on the circuit
for the purpose of safe access for any internal cleaning, recalibration, or maintenance.
This light fitting is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety. Young children should be
supervised to ensure that they do not play with the appliance.
Any changes or modifications made or attempted to this product, without the prior written approval of the
manufacturer, will void any and all stated warranties.
2x
4x 32 mm
2x
1x
6x 30 mm
Rated load: 16W max
Luminous flux: 600 lumens per lamp
Light beam angle: 95° to 1/2 peak intensity
Working temperature: -20° C ~ +40° C
Ingress Protection: IP44
Construction: Polycarbonate UV stabilised
INSTALLING YOUR SENSOR LED MAX LIGHT
This light fitting is rated to IP44. This means that it is suitable in areas which may receive light rainfall. Please ensure the
desired location does not exceed this rating.
SUPERIOR ADJUSTMENT VERSATILITY
Dual Mounting Options
Wall mount
"Click"
Fig A Fig B
Switch off the power supply before commencing electrical work.
Using a flat head screwdriver, carefully lever the side tabs to separate the mounting base from the main housing (Fig A).
Pierce the power entry grommet on the mounting base and slowly draw a round mains power cable through the power
entry hole. Recommended use of 1.5mm² - 2.5mm² wire for installation.
Firmly secure the base to the wall or ceiling using the mounting screws provided. Mounting holes located in the base are
at 60mm centres.
Wire the cable to the terminal block, ensuring accurate polarity. Failure to do this correctly will result in irreparable lamp
and sensor failure. A terminal for Earth parking is provided if required. Locate the main housing over the base and push
together until it 'clicks' into finished position (Fig B).
Adjust the base pivot to orientate the fitting with the sensor adjustors pointing downwards.
Tighten thumb screw to secure. Aim spotlight head to suit the locations.
or
Eave mount
45˚
30˚ 30˚
(60˚ left & right
-2 spot pan together)
"Click"
142.5m m 115mm
Fig C