Allen Organ Company Protege C-19C User Manual page 24

GENERAL MIDI SOUND NAMES:
First, make certain the word USER is selected as the program change mode. Then by
using the "CURSOR" button on the Console Controller™, place the cursor on the second
line of the display following the word DISPLAY. Turn the ROTARY DIAL until the
display shows GEN MIDI following the word DISPLAY. Advance to the next
window function by placing the cursor back on the first line and word "PROG CHG".
Then turn the ROTARY DIAL clockwise until the window function "MIDI PROG
CHANGE" appears on the display. Press any piston to view the General MIDI sound
name assigned to that piston for any General MIDI device.
For example, press General Piston 1. The Console Controller™ will display the MIDI
program change names.
NOTE: In some cases, the General MIDI sound name will be abbreviated in the
Console Controller™ window.
MIDI PROGRAM NUMBERS:
First, make certain the word PRESET is selected as the program change mode. Then by
using the "CURSOR" button on the Console Controller™, place the cursor on the second
line of the display following the word DISPLAY. Turn the ROTARY DIAL until the
display shows NUMBERS following the word DISPLAY. Advance to the next
window function by placing the cursor back on the first line and word "PROG CHG".
Then turn the ROTARY DIAL clockwise until the window function "MIDI PROG
CHANGE" appears on the display. Press a General or Divisional Piston. The Console
Controller™ window will display the same MIDI program change number as the
associated piston pressed. A MIDI program change number will be displayed in
PRESET mode, no matter if NUMBERS or GEN MIDI is displayed. You must select
USER mode to view GEN MIDI sound names. You must also select USER mode to
assign MIDI program change numbers larger than the overall number of pistons on you
model organ.
ASSIGNING MIDI PROGRAM CHANGE NUMBERS
With USER selected as the program change mode (See above instructions to change
modes), along with NUMBERS following the word DISPLAY, you will be able to
assign "- - -" (OFF) or any program change number from 1 through 128 to any General
or Divisional Piston.
After selecting NUMBERS along with USER mode, advance to the next window
function "MIDI PROG CHANGE", then press a General or Divisional Piston to view
the Program Change Numbers assigned to that particular piston. After pressing a General
or Divisional Piston, the Console Controller window will now display the number that
has been selected for that piston. For example, press General Piston 1. The display will
change to indicate that General Piston 1 has been pressed and that BANK 0 is assigned to
that piston. On the second line of the display there may be a number or "- - -" following
the "P:". This "P:" represents the Program Change Number and does not stand for
PRESET in this window. If there is "- - -" following "P:", this means that the "ZERO"
Program Change Number will be sent from the associated piston.
24