Original betaflight spracingf3 firmware. support betaflight flip over function. texas instruments drv8850 brush motor
driver, 5a continuous 8a peak-drive current
each way.
motor protocol must use dshot150 (9 pages)
Page 5
LED OFF: Charge finish Molex 1.25 PH 2.0 1-WAY 4.2V/4.35V Charger Molex 1.25 4.2V/4.35V Switchable (Default 4.35V) PH 2.0 Note:Use 4.35V high voltage to charge the 4.2V battery will damage the battery. LDARC TINY X Series Instruction Manual 2017-12-13 10 Pages-Page 5...
Page 6
High power (above 70%) slow flash Middle power (30%~10%) fast flash + buzzer Low power (less than 10%) <F>:5 channel position switch indicator. <J>: RF indicator. <K>:6 channel position switch indicator. LDARC TINY X Series Instruction Manual 2017-12-13 10 Pages-Page 6...
1.Software 2.Firmware version(Picture 1) 3.Default 4K(Picture 2) 4.Setting the motor mode is brushed(Picture 3) 5.Receiver setting,open UART2 switch(Picture 4) 6.Default setting ARM function use AUX1 channel(Picture 5) 7.PID Setting(Picture 6) LDARC TINY X Series Instruction Manual 2017-12-13 10 Pages-Page 7...
Page 8
Picture1 Picture2 ESC/Motor Features BRUSHED Picture3 Identifier Configuration/MSP Serial RX UART1 115200 Picture4 UART2 115200 115200 UART3 Picture5 ANGLE Picture6 LDARC TINY X Series Instruction Manual 2017-12-13 10 Pages-Page 8...
Page 9
KIT.TINY 6X TINY 7X KIT KIT.TINY 7X TINY 8X KIT KIT.TINY 8X TINY 6X Main frame(2 PCS) PART.TINY 6X MAIN FRAME(2 PCS) TINY 7X Main frame(2 PCS) PART.TINY 7X MAIN FRAME(2 PCS) TINY 8X Main frame(2 PCS) PART.TINY 8X MAIN FRAME(2 PCS) 716 Motor(CW+CCW) MOTOR.716(CW+CCW)
Transmitter functions properly Flying in good condition Camera OK Frame VTX OK Transmitter ID is the same All parts of the installation Insulating sleeves have been installed manual Complete accessories,total packages LDARC TINY X Series Instruction Manual 2017-12-13 10 Pages-Page 10...
Need help?
Do you have a question about the TINY 6X and is the answer not in the manual?
Questions and answers