Adjusting The Transport Speed; Controls System Maintenance; Adjusting The Lift Lever - Toro Sand Pro 3040 Operator's Manual

4. Check for proper operation.

Adjusting the Transport Speed

Obtaining Maximum Transport Speed
The traction pedal is adjusted for maximum transport speed
and reverse at the factory, but an adjustment may be required
if the pedal reaches full stroke before the pump lever reaches
full stroke, or if a decrease in transport speed is desired.
To obtain maximum transport speed, press down on the
traction pedal. If the pedal contacts the stop
before the pump lever reaches full stroke, adjust it:
Figure 35
1. Pedal stop
1. Park the machine on a level surface, turn the engine
off, and engage the parking brake.
2. Loosen the nut securing the pedal stop.
3. Tighten the pedal stop until it does not contact the
traction pedal.
4. Continue applying a light load on the transport pedal
and adjust the pedal stop so that it just contacts or
a gap of 2.5 mm (0.100 inch) is attained between the
pedal rod and the stop.
5. Tighten the nuts.
Reducing the Transport Speed
1. Park the machine on a level surface, turn the engine
off, and engage the parking brake.
2. Loosen the nut securing the pedal stop.
3. Thread the pedal stop out until the desired transport
speed is attained.
4. Tighten the nut securing the pedal stop.
Controls System
Maintenance

Adjusting the Lift Lever

Adjust the detent plate of the lift lever
attachment does not float properly (follow ground contour)
during operation.
1. Park the machine on a level surface, turn the engine
(Figure 35)
2. Remove the 4 screws securing the control panel to the
1. Control panel
2. Screws
3. Loosen the 2 bolts securing the detent plate to the
1. Detent plate
30
off, set the parking brake, and block the wheels.
frame (Figure 36).
Figure 36
fender and the frame.
Figure 37
(Figure 37) if the
2. Mounting bolts