Roland TD-20K Owner's Manual page 15

Assemble the TD-20K
Using the built-in connection cables of the MDS-20, connect the pads, cymbals, hi-hat, kick trigger pad, and percussion sound
module.
To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and turn off the power
on all devices before making any connections.
fig.25.e
TD-20 Rear Panel
AX4 AX3 AX2
HH
HHC
TD-20
• The HI-HAT and RIDE cymbal use two cables each.
• After the VH-12 is connected to the TD-20 percussion sound module, the offset must be adjusted.
• Use trigger inputs AUX1-AUX4 when adding new pads.
* Do not pull or stretch the cables too tight.
* When connecting the cables, please refer to the marking labels that are attached to both ends of the cables.
AX1 RDE RD CR2
CR1
(BOW/EDGE)
CY-14C CY-14C
(TRIGGER OUT)
(CTRL OUT)
VH-12 VH-12
PD-125
CR1 HHC HH
RD
(BOW/BELL)
RDE
CY-15R CY-15R
T1 T2
PD-105 PD-105
SNR
KD-120
KIK
T4 T3 T2 T1 SNR
(BOW/EDGE)
CR2
(BOW/EDGE)
CY-14C CY-14C
T3
T4
PD-125
PD-125
KIK
15