Table of Contents
Advertisement
Adjusting How the Loop
Effect is Applied
The following explains how you can alter the volume of the
signals sent by each track to the loop effects (the send level),
and control the degree to which the loop effects are applied.
1. Press [LOOP EFFECTS].
2. Press CURSOR [
] [
DLY" or "REV," and press [ENTER].
fig.01-705d
3. Press CURSOR [
] [
the send level of each track appears.
When using CHO/DLY
fig.01-706d
When using REV
fig.01-707d
4. Use [CURSOR] and the TIME/VALUE dial to adjust
the send level for each track.
* Pressing a REC TRACK button moves the cursor to the track
corresponding to the button pressed.
] to move the cursor to "CHO/
] to select the screen for setting
Using the Loop Effects/Track EQ
If you then press CURSOR [
the input-source send level appears in the display; if you
press CURSOR [
], the one for setting the Rhythm
send level is displayed.
fig.01-708d
fig.01-709d
To adjust the send level for the input source, move the
cursor to "In Send." To adjust the send level for the
Rhythm, move the cursor to "Rhy Send." The setting is
adjusted by turning the TIME/VALUE dial to the
desired value.
5. After you have completed adjusting the send level,
press [EXIT] repeatedly to return to the Play screen
You can switch screens in the following sequence, with the
screen cycling to the next screen each time [LOOP EFFECTS]
is pressed.
Loop Effects selection screen → Send Level screen →
Type screen → Play screen
], the screen for setting
109
Advertisement
Table of Contents
