Table of Contents
Advertisement
■ Setting Sync Mode
When connecting an external MIDI device and
synchronizing the performance, this determines
whether the DR-3 is to be the slave.
1. With the performance stopped, press
[EDIT].
The Edit Menu screen appears.
2. Press [
], select a <SYSTEM>, then
press [ENTER].
3. Press [
], select a <Sync>.
fig.10-03d
4. Turn the VALUE dial to set the value.
Param-
Value
eter
AUTO
Sync
REMOTE
INT
5. Press [EXIT] a number of times until you
exit Edit mode.
*
When the DR-3 is functioning as a slave device, the
tempo cannot be controlled from the DR-3.
Description
When the performance is
stopped and a Start mes-
sage is input from an exter-
nal MIDI device, the DR-3
automatically switches to
slave.
Messages input from the
external MIDI device are
used only to control start-
ing and stopping.
You can use Note messages
from external MIDI devices
to play the DR-3's internal
sound generator, without
synchronization.
Chapter 11 Connecting and Using External MIDI Devices
Using An External MIDI
Device to Play the DR-3
You can use performance data transmitted from
an external MIDI device to play the DR-3.
fig.10-05
MIDI Channels
In order to exchange performance data between
an external MIDI device and the DR-3, the MIDI
channel settings must be the same for both
devices. Performance data can be exchanged
successfully only when the MIDI channels match.
For more on the DR-3's MIDI channel settings,
refer to "Setting the MIDI Channels" (p. 94).
MIDI Keyboard
MIDI OUT
MIDI IN
DR-3
95
Advertisement
Table of Contents
