When Using Realtime Recording - Boss Dr. Rhythm DR-3 Owner's Manual

3. Press [ENTER] to determine the pattern
to be recorded.
The measure numbers advance automatically.
The asterisk (*) indicates that the pattern
displayed has not been confirmed. If you press
[EXIT] at this point, the pattern that has already
been set appears in the display. If no pattern has
been confirmed, "- - - -" is displayed. Once you
confirm the pattern, the asterisk disappears.
4. Press [
] [
be recorded.
5. Repeat Steps 2–4 as needed to record the
data for the song.
6. To stop recording, press STOP [
The STEP REC [
* Note that pressing START [
Recording (while STEP REC [
DR-3 to Realtime Recording.
Erasing Previously Recorded Sounds
As You Continue Recording
You can use the following procedure to delete the
displayed pattern.
1. Press [
] [
be deleted.
2. Hold down STEP REC [
[ENTER].
The pattern is deleted, and the subsequent
patterns are shifted forward.
] to change the step to
].
] goes out.
] during Step
] is lit) switches the
] to display the pattern to
] and press
Chapter 8 Creating and Performing Songs ([SONG])

■ When Using Realtime Recording

The sounds are recorded as the patterns are
switched with the pads.
* When recording over a song that has already been
recorded, the newly recorded data overwrites the
previously recorded data, which is discarded.
Make sure you have pressed [SONG] to switch to
Song mode.
1. Hold down STEP REC [
START [
fig.08-02d-1
2. Turn the VALUE dial to select the style,
and press a pattern pad to specify the
first pattern to be recorded.
Recording begins from the pattern specified.
The Song Recording screen appears.
fig.08-05d
Song No.
Measure
3. Perform by switching the patterns with
the pattern pads.
Perform exactly as in Style Manual mode (p. 43).
The ON/OFF status of the VARIATION
[PTN], [KIT] and [MUTE] (p. 45) is also
recorded.
You can also change styles by turning the
VALUE dial.
* If you switch the style during its performance, a "
mark appears in front of the style name which will be
played next. The style switches after the currently
playing pattern ends, and the "
* The ON/OFF status of the VARIATION buttons and
fill-ins can be recorded only in a unit of pattern.
4. When you press [ENDING/STOP], the
ending is played, and then both the
performance and the recording stop.
If you want to stop the recording
immediately, press STOP [
] and press
].
Style No.
Pattern Name
" mark disappears.
].
"
77