Table of Contents
Advertisement
Chapter 11 Connecting and Using External MIDI Devices
Data Synchronized with the DR-3
The following MIDI messages are handled
during synchronization with the DR-3.
•
Start
•
Timing Clock
•
Continue
•
Song Select
•
Stop
•
Song Position Pointer
*
For more information on the MIDI messages handled by
the devices you are connecting, refer to the owner's
manual for each device.
*
When synchronizing a drum machine connected to the
DR-3, you should set things up so that sounds are not
played by the DR-3's internal sound generator in
response to Note messages received from the connected
drum machine. Either prevent Note messages from being
transmitted by the connected device, or set the DR-3 so it
doesn't receive Note messages. For more on the DR-3's
MIDI channel settings, refer to the following.
94
■ Setting the MIDI Channels
To enable proper reception of performance data,
the MIDI channels for the transmitting and
receiving devices must be matched.
You can assign the drum part and bass part to
different MIDI channels.
1. With the performance stopped, press
[EDIT].
The Edit Menu screen appears.
2. Press [
], select a <SYSTEM>, then
press [ENTER].
3. Press [
], select a <DrumMidiCh> or a
<BassMidiCh> to be set.
fig.09-08d
4. Turn the VALUE dial to set the value.
Parameter
Value
Drum
OFF,
MidiCh
1–16
Bass
OFF,
MidiCh
1–16
*
Program Change messages are received on the drum part
MIDI channel.
5. Press [EXIT] a number of times until you
exit Edit mode.
Sets the drum part MIDI
channel
When set to "OFF," Note
and Program Change mes-
sages are not received.
Sets the bass part MIDI
channel
When set to "OFF," Note
messages are not received.
Advertisement
Table of Contents
