Yamaha SWR2311P-10G Owner's Manual page 5

L2 switch
Hide thumbs Also See for SWR2311P-10G:
Table of Contents

Advertisement

Do not open
• This product contains no user-serviceable
parts. Do not attempt to disassemble the
internal parts or modify them in any way.
Water warning
• Do not expose the product to rain, use it
near water or in damp or wet conditions,
or place on it any containers (such as
vases, bottles or glasses) containing
liquids which might spill into any
openings.
• Never insert or remove an electric plug
with wet hands.
• Do not place any burning items or open
flames near the product, since they may
cause a fire.
Hearing loss
• When turning on the AC power in your
audio system, always turn on the power
amplifier LAST, to avoid hearing loss and
speaker damage. When turning the
power off, the power amplifier should be
turned off FIRST for the same reason.
CAUTION
Always follow the basic precautions
listed below to avoid the possibility of
physical injury to you or others, or
damage to the product or other
property. These precautions include,
but are not limited to, the following:
Power supply/power cord
• When removing the electric plug from the
product or an outlet, always hold the plug
itself and not the cord. Pulling by the cord
can damage it.
Location and connection
• Do not place the product in an unstable
position where it might accidentally fall
over and cause injuries.
• Keep the device and small parts out of
reach of children, to keep them from
putting their fingers into openings on the
product and accidentally being injured.
There is a danger that children might
swallow small parts. This product is not
suitable for use in locations where
children are likely to be present.
• Do not block the vents. This product has
ventilation holes at the top/front/rear/sides
to prevent the internal temperature from
becoming too high. In particular, do not
place the product on its side or upside
down. Inadequate ventilation can result in
overheating, possibly causing damage to
the product(s), or even fire.
• When installing the product:
- Do not cover it with any cloth.
- Do not install it on a carpet or rug.
- Make sure the top or side surface faces
up; do not install on its front, rear, or
upside down.
- Do not use the product in a confined,
poorly-ventilated location.
Inadequate ventilation can result in
overheating, possibly causing damage to
the product(s), or even fire. If this product
is to be used in a small space other than
an EIA-standard rack, make sure that there
is adequate space around the product: at
least 2.5 cm above, and 10 cm behind.
• Do not use the separately sold WK-SWR
wall mount accessory to attach the unit to
a ceiling that is higher than 2 meters. If the
unit falls, injury or damage might occur.
• If the product is mounted in an EIA
standard rack, carefully read the section
"Please read before mounting the unit into
a rack" on page 20. Inadequate
ventilation can result in overheating,
possibly causing damage to the
product(s), malfunction, or even fire.
SWR2311P-10G Owner's Manual
5

Advertisement

Table of Contents
loading

Table of Contents