Installation On A Wall Or Ceiling - Yamaha SWR2311P-10G Owner's Manual

Installation on a wall or ceiling

Installation on a wall or ceiling
Use the separately sold WK-SWR wall mount accessory to install the unit.
If attaching this unit to a ceiling, invert the top and bottom of the unit.
You will need to obtain six screws that fit the holes described in step 1 and are appropriate for
the material and thickness of the wall or ceiling.
Carry out the installation completely, all the way to step 7.
Warning
Do not attach this unit to a ceiling that is higher than 2 meters.
If the unit falls, injury or damage might occur.
Caution
When attaching or removing this unit, you must disconnect the unit's power
•
plug from the power outlet.
Failing to do so could cause electrical shock or malfunctions.
• Installation must be performed by a qualified installer.
During installation, pay attention to the following points.
• Choose hardware and a location that is well able to support the weight of this unit
• Avoid locations that are subject to sustained vibration
• You must use the specified installation accessory
• Perform periodic maintenance checks
Notice
The mounting accessory has a surface to which the SWR2311P-10G must be attached and a
surface that must be attached to the wall.
If these two surfaces are confused, it will not be possible to attach the mounting accessory to
the SWR2311P-10G. To distinguish the surfaces, refer to the illustrations for step 1 and step 3.
1.
Place the mounting accessory against the wall, and mark the installation
location.
2-R2.5
ø10
5
2- ø 5.5
22
SWR2311P-10G Owner's Manual
SWR2311P-10G
Attachment surface
(not stamped)
Wall installation
Mark the
wall
WK-SWR WK-SWR
surface
(stamped)